Robe ROBIN T1 PC - 5. Remotely Controllable Functions; 5.1 Colour Influencing Functions

14
5. Remotely controllable functions
5.1 Colour inuencing functions
Factory setting of menu functions (channels) which inuence behaviour of colour channels is the following:
Function Factory setting Function Factory setting
DMX mode 1 Uniformity O󰀨
Colour calibration mode On Colour mix control 0 DMX
Colour mixing mode CMY CTC 110 DMX (5600K)
Dimmer curve Square law CRI Selection Standard (80)
Tungsten e󰀨ect simulation O󰀨 Green correction Uncorrected
Chromatic white O󰀨 Shutter/Strobe Open (32 DMX)
Light output stability O󰀨 Dimmer Closed (0 DMX)
Colour calibration mode (menu tab "Personality")
The function switches on/o󰀨 an internal control of colours. For a standard operation of the xture the option
should be switched on. Option o󰀨 has to be set during colour calibration of the xture (in this mode some
functions e.g. Tungsten e󰀨ect, Virtual colour wheel are disabled).
Colour mixing system (menu tab "Personality", DMX channel "Colour functions")
This item allows selection between RGB and CMY mode. In both 3-colour controlling modes (Mode 1,Mode 2)
all internal 5 colours are always utilized where possible.
Dimmer curve (menu tab "Personality", DMX channel "Colour functions")
The xture allows you to select a linear dimmer curve or a square law curve.
Tungsten e󰀨ect simulation (menu tab "Personality", DMX channel "Colour functions")
The function simulates behaviour of a halogen lamp during dimming at calibrated white colours 2700K - 4200K.
You can select from various lamp wattage simulation: 750W, 1000W, 1200W, 2000W, 2500W.
If the function Chromatic white is on, the Tungsten e󰀨ect will inuence also mixed colours.
Saving user colours (DMX channel "Colour functions")
To save user colours:
1.Set the function White Point to o󰀨 (Channel Colour Mix Control, range 70-79 DMX).
1.Mix desired colour on colour channels.
2.Stay in desired position of user colours (216-235 DMX) on the Virtual colour wheel for 1 sec.
3.Leave the range of user colours (216-235 DMX) on the Virtual colour wheel.
4. Repeat steps 2-4 for next user colour.
5.To permanently save user colours, stay for 3 sec. at DMX range of 110-114 on the channel Colour functions.
After that the colour system will be reset (this action can last about 2 minutes). Previous user colours will be
overwritten.
Chromatic white (menu tab "Personality", DMX channel "Colour functions")
If the function is on, the CTC channel inuences calibrated white colours and mixed colours (also colours on
Virtual colour wheel).
If the function is o󰀨, the CTC channel inuences calibrated whites only.
Light output stability (menu tab "Personality", DMX channel "Colour functions")
If the function is on, the light output from the xture is immediately reduced to a value corresponding to a thermal
drop of the light intensity from the LED engine (the thermal drop of light intensity - decreasing of the light intensity
on circa 90 % of starting level after rst 5 minutes, then is the thermal drop of light intensity inconsiderable).
Output uniformity (menu tab "Personality", DMX channel "Colour functions")
If the function is on, the light intensity from the xture is corrected in order to get approximately the same light
intensity as from another xture which has also the function on. Light outputs from more xtures will have
approximately the same light intensity. Thanks to the function, light outputs from more xtures will have ap-
proximately the same light intensity.