15
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so a that it is as straight as possible extending
either above or below the radio.
2. Press the
On / Standby button to switch on your clock radio.
3. Press the
Mode button to select the FM band.
4. Press the Tuning Up or Down button to tune to a station. The
frequency will change in steps of 50kHz.
If the radio is tuned to a station of sufficient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set the Volume
to the desired setting.
7. To switch off your clock radio press the
On / Standby button.
4
3
2
4
To Next Page
Loading...
