85
Headphone socket
A 3.5mm Headphone Socket located on the rear of your radio is provided for use
with headphones. Inserting a plug automatically mutes the internal loudspeaker.
Please be aware that the sensitivity of headphones can vary widely. We therefore
recommend setting volume to a low level before connecting headphones to the radio.
IMPORTANT: Excessive sound pressure from earphones and headphones can
cause hearing loss.
To prevent possible hearing damage, do not listen at high volume levels
for long periods.
DC
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your radio is provided for
connecting the audio signal from an external audio source such as an MP3 or CD
player.
1. Connect a stereo lead from the headphone output of your MP3 or CD player to
the Aux In socket located at the rear of the radio. Typically this lead will have
a 3.5mm stereo plug at both ends.
2. Switch on your radio.
3. Press the Mode button until Aux in mode is shown on the display.
4. Press the 'play' on the connected audio device. If you are using its headphone
output for the connection, set its volume control to a level of somewhere between
two-thirds and maximum (the objective is to get a strong audio signal but without
too much distortion). Then adjust the volume on the radio as required.
Note, if using an iPod as the sound source, you may need to set its output to
maximum to get an adequate audio signal level.
5. After use, disconnect your player by removing the cable from the Auxiliary input
socket in order to listen to your radio conventionally.
3
DAB Radio
My Music
FM Radio
Aux In
h
ttp://
Inter net
Radio
AUX
To Next Page
Loading...
