To Next Page

To Previous Page

DEDB = Deadband for auto changeover = the number of degrees that the

room temperature can move away from the active setpoint until

heating or cooling is called for. The larger the deadband the

more the room temperature will vary. This can be from heat to

cool or cool to heat.

HI = High Heat Limit = This is the highest allowed heating setpoint. The

user will not be allowed to set a schedule setpoint or override

temperature higher than this value.

NOTE: High Heat Limit is not enforced in auto changover mode.

LO = Low Cool Limit = This is the lowest allowed cooling setpoint. The

user will not be allowed to set a schedule setpoint or override

temperature lower than this value.

NOTE: Low Cool Limit is not enforced in auto changover mode.

VAC HEAT = Vacation Heat Setpoint = This is the temperature setpoint

for the heating system when a vacation override has been

made active.

VAC COOL = Vacation Cool Setpoint = This is the temperature setpoint

for the cooling system when a vacation override has been

made active.

Robertshaw RS5110 User Manual

Other manuals for Robertshaw RS5110