9.
CHECKS
AND
CORRECTIONS
After disassembling and cleaning engine, check and repair, if necessary, according to the correction
table. The correction table applies whenever engines are repaired.
f-7
/J
It
is important
for
the servicemen
to
be familiar with contents of this table.
Correct maintenance
is
recommended by observing the correction standards specified.
The meanings
of
the terms used in correction table are as follows
:
(1
CORRECTION
(2)
CORRECTION
LIMIT
Repair, adjustment
or
replacement of any engine
parts.
The limit on wear, damage
or
functional deterioration of engine
parts
beyond which normal
engine performance cannot be expected without repairing such
parts.
The limit beyond which parts can no longer be used in respect
of
performance
or
strength.
The design dimensions of new parts minus tolerance.
Tolerance on. dimensions
of
engine parts refinished
or
adjusted.
(3)
USE
LIMIT
(4)
STANDARD
DIMENSIONS
(5)
CORRECTION TOLERANCE
9-
1
SERVICE
DATA
I
ITEM
CYLINDER
0
Inside dia. (average)
PISTON
Piston
size.
(thrust direction)
Ring groove width
(maximum)
TOP
2nd
mt
TOP
2nd
Unit
:
mm
(in)
,ECOSER
I
EC04ER
37.000-37.01 6
(1.5754-1.5760)
(1
;4581) (1.4567-1.4573)
40.01 4-40.030
37.035
36.95-36.98
(1.5728- 1.5740) (1.4539) (1.4547- 1.4559)
39.95-39.98 36.93
1.63- 1.65
(0.0642-0.0650) (0.0681
)
(0.0642-0.0650)
1.63- 1.65
1.73
1.60- 1.62
(0.0630-0.0638)
(0.0681
)
(0.0630-0.0638)
1.60- 1.62 1.73
Limit
40.049
(1.5767)
39.93
(1.5720)
1.73
(0.068
1
)
1.73
(0.068
1
)
-
30
-
To Next Page
Loading...
Need help?
General
