5. OPERATING YOUR ENGINE
-
8
-
ENGLISHENGLISH
●
Pull the starter handle slowly until
resistance is felt.
This is the "compression" point.
Return the handle to its original
position and pull swiftly.
●
Do not pull out the rope all the way.
●
After starting the engine, allow the
starter handle to return to its
original position while still holding
the handle.
RECOIL STARTER
STARTING
1
Turn the STOP SWITCH
clockwise to the position " I "(ON).
Set the speed control lever 1/3 to
1/2 of the way towards the high
speed position.
STOP SWITCH
SPEED CONTROL LEVER
2
Open the fuel cock.
FUEL COCK
3
5
4
Close the choke lever.
●
If the engine is cold or the ambient
temperature is low, close the
choke
lever fully.
●
If the engine is warm or the ambient
temperature is high, open the
choke lever half-way, or keep it
fully open.
CHOKE LEVER
NOTE
Following operating method is for the STD type speed control lever. As to the fixed type speed
control lever (exp. Generator spec.), do not move it otherwise the generator component such as
voltage regulator may be damaged.
To Next Page
Loading...
Need help?
General
