-
9
-
RUNNING
After the engine starts, set the
speed control lever at the low
speed position (L) and warm it up
without load for a few minutes.
Gradually move the speed control
lever toward the high speed
position (H) and set it at the
required engine speed.
NOTE :
Whenever high speed operation is
not required, slow the engine
down (idle) by moving the speed
control lever to save fuel and
extend engine life.
●
After starting the engine, gradually
open choke by turning the choke
lever and finally keep it fully
opened.
●
Do not fully open the choke lever
immediately when the engine is
cold or the ambient temperature is
low, because the engine may stop.
CHOKE LEVER
6
Insert the key into the key slot and set
it at the" I " (ON) position.
Turning it to the right (START
position) starts the engine.
●
Do not operate the electric starter
continuously for more than 5 seconds,
even if the engine does not start.
●
If the engine failed to start, set the
key to the" I " (ON) position and
wait for about 10 seconds before
retrying.
●
Never turn the key switch to the
START position while engine is
running.
KEY SWITCH (OPTIONAL)
5
SPEED CONTROL LEVER
To Next Page
Loading...
Need help?
General
