(3) Installing friction plate, retaining ring C
-1 Install by putting the friction spring end into the
spring part of the ratchet guide.
Align the cut of the friction plate to the cut of the
recoil starter main body, and fasten with the
retaining ring C.
Be sure that the retaining ring is fitted into the
grooves.
Caution:
Please wear protective goggles before starting assembly.
2) Assembly procedure
(1) Assemble the reel into the case.
-1 Install the ratchet, and fasten it with retaining
ring E.
-2 Install the spiral spring in the reel.
-3 Apply grease to the case.
-4 Properly orient the inner end of the spring installed
in the reel.
-5 Hold the reel so that the shaft and hook part can
be caught on the inner end of the spring, and
softly drop into the case from the top.
-6 Move the reel gently in the counter-clockwise
direction, making sure that the spring catches.
To Next Page
Loading...
Need help?
General
