ROBINHOOD COMCAN60W - Operating Instructions; Start Using Your Cooker Hood; Troubleshooting

5
Operating Instructions
START USING YOUR COOKER HOOD
1. Push the stop button, and the motor will stop.
2. Push the low button, and the motor will start running at low speed.
3. Push the mid button, and the motor will start running at medium speed.
4. Push the high button, and the motor will start running at high speed.
5. Push the lamp button and the two lights will illuminate. Push it again and the lights will turn off.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not work;
motor does not work
House fuses blown
Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to power
outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet are not
tightly sealed
Take down the one-way valve and seal
with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working
Broken or faulty bulbs
Replace bulbs as per this
instruction.
Insufficient suction
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the correct
distance.
The Cooker hood
inclines
The fixing screw is not tight enough
Tighten the hanging screw and make it
horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service
center if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when
opening the unit.