7
Cleaning and Maintenance
NOTE:
• Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
• When activated carbon filter attached, the suction power will be lowered.
BULB REPLACEMENT:
NOTE:
• The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.
• Always switch off the electricity supply before carrying out any operations on the appliance. When handling
bulb, make sure it has completely cooled down before any direct contact with hands.
• When handling bulbs hold with a cloth or gloves to ensure perspiration does not come in contact with the bulb
as this can reduce the life of the bulb.
1. Remove the grease filter.
2. Use a screwdriver to remove the wire cover.
3. Put the lamp outwards by hand, remove the wire terminal to replace the lights.
4. Apply the reverse procedure to reinstall the lights.
To Next Page
Loading...
