11
Transportation of the machine
Depending on the method of transportation or shipping, you will receive the machine in a crate or on
transport blocks..
Always check if the payload of your hoist is sufficiently large. Lift the machine a few inches up and take
the bars or the bottom of the coffin away.
Make sure not to damage the frame when lifting the machine, put some cloth between the hoisting
band and the frame.
After unpacking, check that the machine for damages occurred during transport or during unloading.
Place the machine on a concrete base and level the machine horizontally in both directions.
Electrical connections
The electrical connections must be carried out by a qualified electrician who is able to
calculate the exact needed wire section and caliber of fuses.
- Check whether the mains voltage of your machine corresponds to that of your workshop.
- Connect the plug to the connection plug (16 or 32A).
- Always ensure proper earthing and connect it to the terminal marked with the earthing symbol
(the earth conductor is yellow-green).
- If the machine is an X1 version, then the neutral conductor (N, blue) must be connected. If this
does not happen, the touchscreen screen will not work.
- Check the direction of rotation of the planer shaft motor. If the direction is wrong, the wires L1
and L2 must be exchanged.
- If the direction of rotation of the planer shaft motor is correct, the other motors also rotate in
the correct direction.
ATTENTION:
The machine is equipped with overload protection, and should the motor be shut-off
by this protection, it is necessary to wait for a few minutes untill the overload has cooled
down, and resets itself.
To Next Page
Loading...
