35
Feed the Extension Cable
into the Power Supply unit.
Slide the Base Station’s
head back into place on
the sliders (C). Make sure
it is inserted properly all
the way through. Press
the
lever down until it clicks
in place.
Attach the Perimeter Wire
connector to point A on
the Base Station’s head.
Attach the 20 m (65 ft)
extension cable to point
B on the Base Station’s
head.
Place the Base Station in
its location and align it so
that it’s centered over the
Perimeter Wire. Insert
two stakes as shown. The
remaining stakes will be
inserted at a later stage.
Insert
2 rear
stakes
BA
Be careful not to damage irrigation pipes when hammering
down the stakes.
Press &
Click
To Next Page
Loading...
