11
Getting Started
Assembly
1. Take the screwdriver from its storage bin at the bottom of the base.
4. Place the dock on a hard and at oor (wood/tile/concrete etc.).
Keep at least 0.5 m (1.6 ft) of clearance on either side, 1.5 m (4.9 ft)
in front, and 1 m (3.3 ft) above. Check the location has good WiFi
then plug it in.
3. Connect the power cable to the dock, and keep excess cable
inside the storage slot.
2. Place dock upside down on a soft, at surface (carpet/towel/
cloth) and attach the base by using the six screws provided.
≥
0.5 m (1.6 ft)
≥
0.5 m (1.6 ft)
≥
1.5 m (4.9 ft)
≥
1 m (3.3 ft)
Hold the dustbin cover securely when upside down to prevent damage
from falling.
Note:
To Next Page
Loading...
Need help?
General
