Name: Roborock S6 Pure
Brand: Roborock
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Installation

Using the robot

6. Mopping

Note:

• It is recommended that all floors are vacuumed at least three times before the first

mopping session to reduce excessive dirt buildup on the mop.

• Use barrier tape to prevent mopping carpeted areas, or remove carpets prior to

mopping.

• To prevent corrosion or damage, do not use cleaning fluid or disinfectant in the

water tank.

• Cleaning the mop cloth every 60 minutes is recommended to ensure the water

flow rate and cleaning eect.

Adjust flow rate

Toggle the switch to adjust the flow rate according to your

needs.

Low

High

Fill the water tank

Open the water tank, fill it with water, and close it tightly.

Install the mop cloth

Dampen the mop cloth and squeeze it until it stops dripping.

Insert it into the mounting slot in the water tank.

Install the module

Slide the mop module in line with the alignment marks on

the rear of the machine until you hear a "click".

Other manuals for Roborock S6 Pure

Questions and Answers:

Need help?

Do you have a question about the Roborock S6 Pure and is the answer not in the manual?

General