⑰ROI ON, click to turn on the ROI function;
⑱ROI OFF, click to turn off the ROI function;
⑲RESET, click to soft restart the LiDAR;
⑳OpenFile, open the firmware path;
○
21 Download, start the download program;
○
22 Detail is the output terminal of operation information results.
C.3.3 Tool Usage
C.3.3.1 Get LiDAR Information
Step1. Open the tool. Double-click the program to enter the basic interface, click the
drop-down option of the Project button at the top right, and select M0210, the interface
is as follows:
Step2. Enter Link mode. Please confirm the source IP and target IP of the LiDAR before
clicking [Link]. If the LiDAR is in the default state, click [Link] to enter Link mode. If
[Unlink] appears on the right of [Link], it has entered Link mode. The interface is as
follows:
If the source IP and target IP of the LiDAR is not in the default state, they need to be
modified before entering the Link mode, otherwise, errors will occur. The error interface
is as follows:
To modify the IP, enter the desired IP in the edit box and click the corresponding option on the
To Next Page
Loading...