What to do if ROBOTIQ Digital Camera's input voltage is insufficient or temperature is too high?
Ensure the power supply delivers 24 V DC +/- 10%. Also, the ROBOTIQ Digital Camera should not be used if the ambient temperature exceeds 50°C.
Why is my ROBOTIQ Digital Camera not communicating?
To resolve this, either start or cycle the Vision server. Navigate to the Installation tab, select Camera, then the Camera tab. Click 'Start camera' to initiate the Vision server. Upon successful startup, the output image will appear, and the LED will turn blue. Also, verify the USB cable connection and the software package versions.
What to do if ROBOTIQ Digital Camera is in fault or booting?
Allow the booting process to complete. If the LED remains solid blue and red, disconnect and reconnect the Camera's USB cable to power cycle it. The red LED should then be solid red. Reconnect the USB cable; the LED should turn solid blue once communication is established with the Vision server. You can initiate this communication by clicking 'Start camera' from the Installation tab.
What to do if ROBOTIQ Wrist Camera Robotics camera input voltage is insufficient?
If your ROBOTIQ Robotics camera's input voltage is insufficient or the temperature exceeds 70°C, ensure the power supply is 24 V DC +/- 10%. The Wrist Camera should not be used if the ambient temperature is higher than 50°C.
What to do if ROBOTIQ Wrist Camera camera is in fault?
If your ROBOTIQ Robotics camera is in fault or booting, first wait for the booting process to complete. If the LED remains solid blue and red, disconnect and then reconnect the camera's USB cable to power cycle it, so that the red LED should be solid red. Then reconnect the USB cable. After this, the LED should turn solid blue when communication is established with the Vision server. You can start the Vision server by clicking 'Start camera' from the Installation tab.
General| Connectivity | USB 2.0 |
|---|---|
| Operating Temperature | 0°C to 45°C |
| Communication Protocol | TCP/IP |
| Frame Rate | 30 FPS |
| Sensor Type | CMOS |
| Focus Type | Fixed Focus |
| Weight | 0.23 kg |
| Minimum Object Size | 5 mm |
| Interface | USB |
| Compatibility | Universal Robots |
To Next Page
