6. Robstep M2Steps to Drive
You should pay attention to related safety notes during using Thus, you must fully understand all notes in this manual beforeRobstep M2.
driving, and it is very important to understand these safety notes before using.
◆ Before using, please make sure is assembled, and charge the battery continuously for more than 4 hours. For installation ofRobstep M2
specific parts and charge of the battery, please see this manual.
◆ Before driving, you should fully know the driving environment.
◆ Please wear a safety helmet and protective clothing before driving Robstep M2.
◆ Please do not wear sharp objects to avoid injury during driving.
◆ Robstep M2 is a traveling tool for one person, and only one person can stand on the transporter body during using.
◆ .When you practice driving, please do it on a spacious and flat indoor or outdoor site with the area of at least At the same time ,5m*5m
please make sure the site is safe and spacious, the ground is flat, and no car, pedestrian, pet, bicycle or other obstacle inte rfere the practice.
◆ Please do not practice driving on wet and slippery ground.
6.1 Startup of Transporter Body
Description of startup steps
When you start for the first time or did not use it for aRobstep M2
long time, please turn on the system power (for normal startup,
please ignore this step)
Then, use the remote controller to control accordingly (for
detailed functions, please refer to Chapter 3 Information
about Remoter Controller for Robstep M2)
17
Startup Key
Normal
Mode
Startup Key
Beginner
Mode
Power Button
Power-off
Key
Mute Key
To Next Page
Loading...