Robstep M2 - 2. Product Introduction; Principle of Operation

◆ Method to acquire the serial number:
Acquire from the packing case or the registration card (please take care of the serial number after acquisition).SN
2.3 Principle of Operation
◆ Robstep M2 mainly comprises the transporter body, wheels and a circuit system.Wheels are installed on both sides of the
transporter body, and modules of the circuit system such as the power supply, a control circuit, a driving circuit, sensors and a
control switch are installed in the transporter body.The wheels and the transporter body are connected by a rotary shaft, and a
speed sensor, a gyroscope and an acceleration sensor transfer the rotary speed of wheels and the posture information of the
transporter body to the control circuit, for controlling the torque and the moving speed of a motor to keep the balance of Robst ep
( 2M petsboR2M petsboRMpetsboR 2 and the user). When the use
r stands on correctly, can match well with their body, and a
power device controls the wheels to move forward or backward to keep balance when the body slightly inclines forward or
backward.
◆ The handle has the function of controlling the transporter body to turn. When the handle turns, the transporter body turns.
◆
The inertial dynamic balancing and stabilization system built in Robstep M2 can keep the balance of the transporter body
from front to back.However, the system cannot control the stable balance from left to right, so when the driver turns, their ce nter of
gravity must incline toward the steering rod, to overcome the centrifugal force of steering and increase the safety of steering .
WARNING
!
2M petsboR.3 Information about Remote Controller for
3.1 Overview of Remote Controller
◆ The remote controller for Robstep M2 is a chargeable device with the functions of information display and control, the maximum
remote control distance is 10 m, and you can remote control and monitor the operating conditions of 2M petsboR2M petsboR
within this range.
◆ When using the remote controller for for first time, you need to use a pin to lightly press the reset key in the reset holeRobstep M2
for activating the remote controller.
3