2M petsboR.7 Maintenance and Servicing of
ot.◆ Robstep M2 This chapter mainly describes steps and important promptsThe user needs to perform routine maintenance of
service or maintain Robstep M2.
◆ Before performing the steps below, please make sure the power supply and the charging cable of are disconnected.WhenRobstep M2
the transporter is powered on or the battery is charged, please do not perform the steps below.
WARNING
!
7.1 Handling Notes
Lift and put down with proper skills, and follow the steps below:Robstep M2
◆ Make sure is not connected with the charger and is powered off.Robstep M2
◆ Lift the transporter body with one hand, and grip the foot of the lever for the next grade of the handle with the other hand to lift Robstep
M2 for handling.Please do not use the casing of the transporter body as the bearing point for handling.You can also use the rear rack of
Robstep (a secondary handling part) to handle easily.
7.2 Maintenance
◆ Check tire components regularly. Shake the tires along the rotary direction by hand, and observe whether tire components shakes . If
they shake, please check the bots used to install the tire and screw tightly.
◆ Check the right and left tires for serious wear regularly. If the tires are worn, please contact the after-sale department to c hange them.
◆ Please check
the screws used to connect the handle and handle lever components together, and tightly screw if they are loose.
◆ Every time before use, please check the locking part of the quick release for loosening, and check the lock spanner for tightne ss and
serious wear. You can try to shake the locked handle lever. If the handle lever shakes or loosens, please check the locking part of the
quick release for damage. If the locking part has no damage, you only need to lock the lock spanner.
◆ Check the parts for damage regularly. If it is necessary to change them, please contact Robstep' authorized agents or after-sal e
department.
22
To Next Page
Loading...