◆ The reset key is built in the remote controller. When you insert a pin into the reset hole, please insert straight and do not pr ess hard.
◆ It is recommended that you charge the remote controller fully before use at the first time.
◆ Please make sure the battery of the transporter body is installed correctly before you operate the remoter controller.
◆ Please make sure the charging port and the data plug are dry before you charge the remote controller.
◆ The time to fully charge the remote controller is 4 hours, and overcharging has adverse effect on performance of the battery.
◆ It is necessary to charge the remote controller for startup when the remote controller fully charged is powered off for more than 10 days.
NOTE
!
3.2 Startup of Remote Controller
◆ The remote controller for starts upRobstep M2
when you hold down the " " key.
4
◆ Reset hole (Please use a pin
to press this position
slightly)
◆ Start Screen of
Remote Controller
To Next Page
Loading...