1. Clock Setting
Press and hold button for over 3 seconds until the numbers on the screen flash.
Use button ▲ to adjust hour and ▼ to adjust minute. To submit clock setting, press the button or
idle over 10 seconds the setting will be automatically submitted.
2. Power Save Mode Setup
MULTICLIN is featured a power saving mode to reduce electrical power consumption when not in use.
Once the setting is completed the power save function would turn the product on and off each day
according to your time settings.
Setting Powersave Start and End Time:
1) Press & hold for 3 seconds. "START" on LCD will blink.
2) Powersave Start Setting: Press ▲ to adjust hour. Press ▼ to adjust minute. Press & hold button
to finish the Start Time setting.
3) Powersave End Setting: "END" on LCD will blink. Press ▲ to adjust hour. Press ▼ to adjust minute.
Press & hold button to finish the End Time setting.
IMPORTANT
The LCD screen will show when entering Powersave mode and the Powersave LED on the seat
will be orange.
IMPORTANT
The LCD screen will show when not entering Powersave mode and the Powersave LED on the seat
will be green.
3. Enable and Disable Powersave:
Press the button alternatively to change the state of Powersave. Sitting on the seat when in
Powersave mode the product will restore to regular operation and re-enter Powersave mode on the next
setting start time.
4. Remote Control Beeping/Silent Mode
Press and hold button for over 3 seconds to enable beeping sound, and repeat to return silent
mode.
SETTING ADJUSTMENT
12
OPERATION
OPERATION
IMPORTANT
There should be LED backlights on the remote control when you press any button and light out after 5
seconds. If the remote commander is in low power the backlight will be disable.
This icon on the screen, shows low battery level. Please, replace the batteries.
Remote Control
To Next Page
Loading...
