Roca Multiclin Premium RF - Operating the MULTICLIN; Cleaning Function and Water Pressure; Nozzle and Water Temperature Adjustment

10
OPERATION
OPERATION
1. Cleaning function adjustment-water pressure
1) Sit on the MULTICLIN , the sensor will be activated and the led will be active MULTICLIN has a touch
sensor to avoid the operation in case nobody is seated
2) Selecting cleaning function.
- For Anal (rear cleaning), please press button.
- For Perineal (front cleaning), please press button.
- Water Pressure settings. Press ▲ or ▼ to adjust water pressure.
- Pressing the buttons repeatedly until the preferred pressure is reached. There are five levels of water
pressure adjustment.
3) The function displayed on the LCD :
4) Stop cleaning
- Press button to stop the water cleaning.
Note:
1) Cleaning function will automatically stop after 5 minutes. Please push the button again to activate the
function.
2) This product is equipped with a high pressure release device. It’s normal an small flow of water on the
bottom part of the product during cleaning function
3. Adjusting Water Temperature
1) Press button to adjust the water temperature. Repeat until preferred level is achieved.
2) There are four temperature levels: OFF<low<medium<high
3) The function displayed on the LCD :
LowOff
Medium
High
2. Nozzle Position Adjustment
1) Press button to with the cleaning function (anal or perineal) activated.
2) Press ▲ or ▼ to adjust nozzle position for a more accurate cleaning. Moving the nozzle back and
forth for a wider and thorough cleansing.
3) There’s 5 nozzle position and the LCD display will show:
4. Oscillating Cleaning
1) Press button to activate/deactivate the oscillating spray.
2) With the massage cleaning activated, nozzle will move back and forth, increasing the cleaning area.
Remote Control
35˚ C 37.5˚ C 40˚ C (±2°C)
Note:
Both cleaning function can’t
working at the same time.