47
Meter Maintenance and Troubleshooting
8
Chapter 8: Meter Maintenance and Troubleshooting
Meter Maintenance
The meter automatically tests its own systems every time you turn it on and lets you know if something
is wrong. See the Error Messages section in this chapter.
If you have problems with the meter, drop the meter, or think the results are not accurate, perform a
control test with an unexpired test strip and control solution. If the control result is not within the
acceptable range, contact the Accu-Chek Customer Care Service Center at 1-800-858-8072.
WARNING
Keep new and used batteries away from children. See the warning in the Important Safety
Information of this User’s Manual for additional information.
Changing the Batteries
Open the battery door on the
back of the meter by
pushing the tab in the
direction of the arrow and
pulling the door up.
1
SN XXXXXXXXXXX
PIN XXXXX
xxxxxxx, xxxxxxx
xxxx/x
GTIN XXXXXXXXXXXXXX
Remove the old batteries.
2
Slide the new batteries under
the black tabs with the (+)
side facing up.
Put the battery door back in
place and snap it closed.
3
81265_08500142002_EN_Insides.indb 47 10/28/2019 1:55:04 PM
To Next Page
Loading...
