MagNA Pure Compact Operator’s Manual - Version 1.3
58
B
B
How to Operate the MagNA Pure Compact Instrument
B
B
The CONFIRMATION Screen appears. While at this
screen, do the following:
䉴 Check the information display and:
- if the information is correct, confirm it by
touching the "Confirm Data" button, or
- if the information is not correct, touch the
Previous button as many times as
necessary to go back to one of the earlier screens
and change the erroneous information. Once the
information is correct, touch the Next button
(repeatedly) to return to the
CONFIRMATION screen, then touch the
"Confirm Data" button.
䉴 Make sure the Drop Catcher is present on the
Preparation Stage, then touch the "Drop Catcher
present" confirmation button.
䉴 Now the Start button will be active. Start the purification by touching this button.
The HEATING Screen will appear displaying the time
needed for heating of the heating units.
When heating is completed, the PROCESS Screen
will appear and remain throughout the entire
purification run.
䉴 As the run progresses, this screen will display the
actual step being performed and the time
remaining.
Note: If you need to interrupt the run before it is
complete, you can execute an emergency stop by
touching the Cancel button. (Before the instrument
actually stops the run, you will need to confirm the
request twice by replying to dialog boxes that
appear.)
䉴The instrument will sound an alarm when the run is
finished. (See Chapter A for information on setting
this alarm.).
Action Handling Software programming
12
13
Performing a Purification Run
Purification
Performing a Purification Run
Purification
59
4_MagNA Pure Compact_ChapterB_2.fm Seite 58 Mittwoch, 8. März 2006 10:13 10
To Next Page
Loading...