_____________________________________________________________________________________________
Subject to change without notice. 13
Programming your Rocket R 58 espresso machine
Your machine is factory set to optimum working parameters.
Nevertheless you can set your personal parameters using the remote controller
(with display) to be connected to the machine.
You can change the settings of the following parameters:
■ Language
■ Hard plumbing to mains or pour over operation
■ Service boiler heating on or off. The service boiler is the one providing steam and
hot water. If you plan to produce only coffee, you can switch the heating of this
boiler off, so only the coffee water boiler (“brewing head boiler”) will be heated.
■ The coffee water brew boiler’s temperature is factory set to 105°C. You can
set the temperature between 95°C and 115°C. The factory setting of 105°C
reflects to an extraction of around 92°C.
■ The pressure of the service boiler is factory set to 1,1 Bar. It can be changed in
a range in between 0,8 Bar and 1,3 Bar.
Fig. D Connecting the remote controller to the machine
Please proceed as follows:
1. Switch the machine off (turning
on/off switch Fig. A/12 to
position “0”).
2. Plug the cable into the machine
(see Fig. D/1). Port left hand
lower side.
3. Now turn machine on (on/off
switch Fig. A/12 to position “1”).
The machine is ready to be programmed.
To Next Page
Loading...
