EasyManua.ls Logo

Rockford Fosgate Punch PBR300X1 User Manual

Rockford Fosgate Punch PBR300X1
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Installation
& Operation
Installation et fonctionnement
Instalación y funcionamiento
Einbau und Betrieb
Installazione e funzionamento
BOOSTED RAIL MONO AMPLIFIER
PBR300X1
Question and Answer IconNeed help?

Do you have a question about the Rockford Fosgate Punch PBR300X1 and is the answer not in the manual?

Rockford Fosgate Punch PBR300X1 Specifications

General IconGeneral
Number of Channels1
Total Harmonic Distortion (THD)< 1%
Input Sensitivity200 mV - 4 V
Fuse Rating25A
Rated Power (RMS)300 Watts
CrossoverLow-pass: 50Hz - 250Hz
Bass Boost0-12dB @ 45Hz

Summary

Introduction

Practice Safe Sound

Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss. High powered auto sound systems may produce sound pressure levels well over 130dB. Use common sense and practice safe sound.

Getting Started

Safety Instructions

This symbol with “WARNING” is intended to alert the user to the presence of important instructions. Failure to heed the instructions will result in severe injury or death.

Design Features

Installation Considerations

Mounting Locations

Never mount this unit in the engine compartment. Mounting the unit in the engine compartment will void your warranty.

Installation: Wiring and Power

Battery and Charging

Amplifiers will put an increased load on the vehicle's battery and charging system. We recommend checking your alternator and battery condition to ensure that the electrical system has enough capacity to handle the increased load of your stereo system.

Wiring the System

Plan the wire routing. Keep RCA cables close together but isolated from the power cables and any high power auto accessories.

Operation

Remote Punch EQ

NOTE:Previous (prior to 2007) Punch Bass and Para-Punch remotes will not work with these amplifiers.

Adjusting Crossover Frequency

The crossover is set to Low Pass only, enabling frequencies below the cut-off point to pass, adjustable between 35-250Hz.

Variable High Level Adjustment

For a high level(speaker) input application the High/Low Level Switch needs to set to High.

Adjusting Gain

To adjust the gain setting, turn the amplifier gains all the way down (counter-clockwise). Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion is inaudible.

Troubleshooting

Procedure 1: Check Amplifier for proper connections

Verify that POWER light is on. If POWER light is on skip to Step 3, if not continue.

Procedure 2: Protect light is on

This is a sign of a possible short in the speaker connections. Check for proper speaker connections and use an ohm meter to check for possible shorts in the speaker wiring.

Procedure 3: Check Amplifier for audio output

Verify good RCA/Speaker input connections at stereo and amplifier. Check entire length of cables for kinks, splices, etc. Test RCA/Speaker inputs for AC volts with stereo on.

Procedure 4: Check Amplifier if you experience Turn-on Pop

Disconnect input signal to amplifier and turn amplifier on and off. If the noise is eliminated, connect the REMOTE lead of amplifier to source unit with a delay turn-on module.

Procedure 5: Check Amplifier if you experience excess Engine Noise

Route all signal carrying wires (RCA, Speaker cables) away from power and ground wires.

Specifications

Limited Warranty Information

Length of Warranty

Source Units, Speakers, Signal Processors and PUNCH Amplifiers – I Year POWER Amplifiers – 2 Years Any Factory Refurbished Product – 90 days (receipt required)

What is Covered

This warranty applies only to Rockford Fosgate products sold to consumers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.

What is Not Covered

1. Damage caused by accident, abuse, improper operations, water, theft, shipping 2. Any cost or expense related to the removal or reinstallation of product

Limit on Implied Warranties

Any implied warranties including warranties of fitness for use and merchantability are limited in duration to the period of the express warranty set forth above.

How to Obtain Service

Contact the Authorized Rockford Fosgate Dealer you purchased this product from. If you need further assistance, call 1-800-669-9899 for Rockford Customer Service.

Extended Warranty Program

What is covered

This warranty applies only to Rockford Fosgate products sold to customers by Authorized Rockford Fosgate Dealers in the United States of America or its possessions.

Who is covered

This warranty covers only the original purchaser of Rockford product purchased from an Authorized Rockford Fosgate Dealer in the United States.

What is not covered

1. Damage caused by accident, abuse, improper operations, water, theft, shipping 2. Any cost or expense related to the removal or reinstallation of product

Limit on Implied Warranties

Any implied warranties including warranties of fitness for use and merchantability are limited in duration to the period of the express warranty set forth above.

How to Obtain Service Under the Extended Warranty Program

The amplifier must be returned by the customer (you) or an authorized Rockford Fosgate retailer with a copy of the original receipt and the ORIGINAL Performance Verification Certificate.

Related product manuals