Need help?Do you have a question about the Rockford Fosgate PUNCH100 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 50W x 2 |
| RMS Power at 2 Ohms | 100W x 2 |
| Bridged RMS Power at 4 Ohms | 200W x 1 |
| Total Harmonic Distortion (THD) | <0.05% |
| Frequency Response | 20Hz - 20kHz |
| Crossover | 12dB/octave |
| Bass Boost | 0dB @ 45Hz |
Details the mounting hardware and fuseholders included with Punch 2-channel amplifiers.
Detailed descriptions of heatsinks, terminals, controls, and features like Gain and Punch Bass.
Essential safety rules, tools required, and advice on pre-planning for amplifier installation.
Guidance on trunk and passenger compartment mounting, with warnings against engine compartment installation.
Covers planning wire routes, avoiding noise, and safety during wiring.
Detailed steps for connecting power, ground, REM, RCA, and speaker wires.
Diagrams illustrating power connections for various Punch amplifier models.
Illustrates RCA and high-level input connections for amplifier models.
Diagram showing power connections specifically for the Punch 800 amplifier.
Explains Low-Pass (LP) and High-Pass (HP) crossover operations with frequency charts.
Details how to use the Punch Bass control for adjusting bass frequencies.
Guide to stereo operation for Punch 100 and 150 models, including connections.
Guide to stereo operation for Punch 250, 360, 500, and 800 models.
Instructions for mono operation on Punch 100 and 150 amplifiers.
Instructions for mono operation on Punch 250, 360, 500, and 800 amplifiers.
Guidance for combined stereo/mono operation on Punch 100 and 150 models.
Guidance for combined stereo/mono operation on Punch 250, 360, 500, and 800 models.
Illustrates a typical 2-way speaker system connection with the amplifier.
Diagnoses and remedies for amplifiers not turning on or producing sound.
Troubleshooting low/distorted output, turn-on pop, and general amplifier noise.
Addresses engine noise, ground loops, and noise with high-level inputs.
Explanation of IHF-202 standards and dynamic power measurement.
How music dynamics are simulated for power testing.
Discusses loudspeaker impedance dynamics versus fixed resistor values.
Explanation of the 3D PowerCube graph axes: Impedance, Voltage, Phase Angle, and Power.
Definition and function of an amplifier in a sound system.
Details what is covered by the Rockford Fosgate limited warranty.
Lists warranty exclusions and instructions for obtaining service.
To Next Page