Rodgers A778 - Unlocking a Combination Memory

To Next Page

To Previous Page

OR, depending on model

1. Use M+ or M- pistons to select the memory level to be locked.

2. Press the QUICK MENU piston. Use the Select knob next to the display to

scroll down until Console appears in the display.

3. Press the QUICK MENU piston. Use the Select knob to scroll down until

MemoryLevel Lock appears in the display.

4. Press the QUICK MENU piston.

5. Turn the Alpha dial until Locked appears in the display.

6. Press the STOP piston (located under the Choir manual to the right) three times to

exit this mode.

Unlocking a Combination Memory

On instruments with combination action pistons M1, M2, etc., any memory level can be

locked using the following procedure:

1. Press and hold the memory piston (M1, M2, M3, etc.) corresponding to the

memory level you want to lock until the Memory Bank screen appears. Internal

or Memory Card and (#) Unlocked or (#) Locked appears in the display.

2. If (#) Locked appears, go to step 3. If (#) Unlocked appears, the memory level is

already unlocked.

3. Turn the Select knob to highlight Locked.

4. Rotate the Alpha dial to select Unlocked. The memory is now unlocked and that

piston can be changed.

On instruments with the M+ and M- pistons, memory level may be unlocked using the

one of the following procedures:

1. Use M+ or M- pistons to select the memory level to be unlocked.

2. Press and hold SET then press and release M+.