Rodgers A778 - Restoring Factory Combination Settings

18
4. Press the QUICK MENU piston.
5. Turn the Alpha dial until Unlocked appears in the display.
6. Press the STOP piston (located under the Choir manual to the right) three times to
exit this mode.
Restoring Factory Combination Settings
If the original factory settings have been overwritten or erased, and you would like to restore
them, use the following procedure:
1. Press and hold the memory piston to be restored (M1, M2, or M3) until the
Memory Bank screen appears. The display shows Memory Bank and Unlocked
or Locked (if locked, see the unlocking procedure in the previous section).
2. Turn the Select knob until Restore Factory appears in the display.
3. Press and release SET.
4. Turn the Select knob highlight No.
5. Rotate the Alpha dial to highlight Yes.
6. Press and release SET.
7. Press and hold Cancel (O) until Transposer O appears in the display.
8. Power the instrument off and on. The selected memory has been restored to
factory defaults.
To restore the default setting using the M+ and M-, use one of the following procedures:
1. Use M+ or M- pistons to select the memory level to be unlocked.
2. Press and hold SET and press M+. The display shows Memory Bank and
Unlocked or Locked (if locked, see the unlocking procedure in the previous
section).
3. Turn the Select knob until Restore Factory appears in the display.
4. Press and release SET.
5. Turn the Select knob highlight No.
6. Rotate the Alpha dial to highlight Yes.
7. Press and release SET.
8. Press and hold Cancel (O) until Transposer O appears in the display.
9. Power the instrument off and on.
The selected memory has been restored to factory defaults.