ROEL Cerber C62 - 1. INTRODUCTION; GENERAL FEATURES; USER CODES; INSTALLER CODES

3
1. INTRODUCTION
GENERAL FEATURES
• Central unit's core of powerful RISC microprocessor;
• The electrical features include an EEPROM memory for the programmed configuration,
system/partitions status and LOG buffer to be retained even after a total power loss;
• User-friendly programming of the system parameters, from keypad or by PC (using “EZcom
C62 Software”);
• Up to 400 events with time and date stamp can be stored in a FIFO LOG buffer;
• “False alarm prevention” features: intellizones, automatic zone shutdown, beeps on entry and
exit delays;
• Features of “sensor under test” for easy detection of the sensors which produce false alarm.
• High-speed pre-programmed or programmable Communication Formats;
• 45 user codes (1
-st
being “master code”) and 2 installer’s codes (programming and maintenance
codes);
• Keypad displayed alarm memory for the first 9 alarms occurred in the system since last
arming;
• Up to 4 keypads which can be simultaneously 4-wire coupled to one central unit;
• Keypad protection using micro-switch tamper;
• Individual zone LEDs from 1 to 6, indicating the alarm and faulted status;
• Each zone accepts tamper recognition by zone attribute programming and 2EOL wiring
• System status LEDs: READY, SYSTEM, ARMED A and ARMED B;
USER CODES
45 programmable “user codes” (1
-st
being “master code”) with 11 programmable rights:
• Zone bypassing;
• Regularly arming;
• Stay arming;
• Force arming;
• Disarming/siren stopping;
• PGM1 activating/deactivating;
• PGM2 activating/deactivating;
• Access to partition A;
• Access to partition B;
• Starting the rounds;
• Finishing the rounds;
• All users have “ambush capability” (by pressing the key which corresponds to the “ambush
digit”, before the 4 or 6 digits of any user code, then the control panel will transmit a special code to
the central station).
INSTALLER CODES
• 2 programmable installer’s codes: installer’s programming code and installer’s
maintenance code (the first installer’s code is only for system parameter programming and the
second one with same 11 programmable rights and “ambush capability” as the 45 user codes, except
the Disarming right which is allowed only if the system/partition was previously armed by the same
code);