Operation
1MA236_0e Rohde & Schwarz Remote Operation of Windows Based T&M Instruments with Android Tablets 20
4.2.3 Starting a Firmware Application on a CMW
Example: Start the LTE signaling and LTE measurement application.
Main line of steps:
1. Load signaling and measurement firmware applications:
Select the "SIGNAL GEN" hardkey. The "Signaling Controller" window is
opened.
You can expand compact tree views by tapping the "+" symbol at a tree knot.
Check the "LTE Signaling" checkbox via virtual mouse.
Select the "MEASURE" hardkey. The "Measurement Controller" window is
opened.
Check the "LTE TX Measurement" checkbox via virtual mouse.
2. Click on the "TASKS" hardkey to get the taskbar.
3. Tap the "LTE Signaling" task on the taskbar.
4. Configure the signaling application by tapping softkeys and hotkeys, by clicking on
check boxes and list boxes. Activate the keyboard for entering values in input box-
es.
5. Start signaling: Tap the "LTE Signaling" softkey, then click on the "ON OFF" hard-
key.
After successful start the softkey label shows "ON".
6. Switch to LTE measurement by selecting the "LTE TX Meas." softkey near the top
of the softkey bar.
7. Configure the measurement application via softkeys, hotkeys, etc.
8. Start the measurement: Tap the "LTE TX Meas." softkey, then click on the "ON
OFF" hardkey.
9. Check/edit the main signaling settings by tapping the "LTE Signaling" softkey while
the LTE measurement view is still displayed. LTE signaling hotkeys are shown in
the hotkey bar at the bottom of the screen.
Note: It is not possible to start a firmware application via keyboard.
4.3 Disconnecting from the T&M Instrument
1. Tap "MORE" on the upper right corner of the screen.
2. Tap "Disconnect".
Fig. 20: Disconnect via 2X Client
To Next Page
Loading...
