R&S FSH Putting into Operation
Connectors on the R&S FSH
Quick Start Guide 1309.6269.12 - 09 25
1.4.6.3 IF Output
The second (lower) BNC connector can be used as an intermediate frequency output
(54.4 MHz).
Risk of instrument damage
To avoid damage to the tracking generator output, never apply currents greater than
600 mA or voltages greater than 20 V to the BNC connectors if the BNC connectors
are not configured as BIAS input ports.
If they are configured as BIAS ports, never apply currents greater than 600 mA or
voltages greater than 50 V.
To Next Page
Loading...
