R&S FSH Putting into Operation
Configuring the R&S FSH
Quick Start Guide 1309.6269.12 - 09 37
1.6.3 Using the GPS Receiver
The R&S FSH can locate your exact position if you equip it with the R&S HS-Z240
GPS receiver (order no. 1309.6700.02) or one of the supported antennas R&S HL300
or R&S HE300.
● The GPS receiver has to be connected to the AUX port.
● The R&S HL300 has to be connected to the AUX port.
● The R&S HE300 has to be connected to the power sensor connector.
GPS reference frequency
Note that the reference frequency is automatically adjusted as soon as the GPS
receiver is enabled and a fix connection with enough satellites is established.
The "Instrument Setup" dialog box provides all settings necessary to configure the
GPS receiver.
In addition, the R&S FSH shows some information about the GPS connection like the
number of tracked satellites or the signal quality.
Enabling the GPS receiver
► In the "Instrument Setup" dialog box, select the "GPS Function" item.
► Press the ENTER key.
A dropdown menu to turn the GPS receiver on and off opens.
► Turn the GPS receiver on or off as required.
► Confirm the selection with the ENTER key.
When this feature is on, the R&S FSH is ready to receive GPS data.
Displaying GPS information
► In the "Instrument Setup" dialog box, select the "Show GPS Information" item.
► Press the ENTER key.
A dropdown menu to turn the display of the GPS coordinates on and off opens.
► Turn the display of GPS coordinates on or off as required.
► Confirm the selection with the ENTER key.
To Next Page
Loading...
