Rohde & Schwarz FSH4 - Resetting the R&S FSH

R&S FSH Putting into Operation
Configuring the R&S FSH
Quick Start Guide 1309.6269.12 - 09 45
1.6.11 Resetting the R&S FSH
You can either preset the R&S FSH or reset it to factory settings.
Presetting the R&S FSH
The PRESET key resets the R&S FSH to the default setup of the currently active
operating mode.
This allows you to define a new configuration based on defined measurement
parameters without parameters from a previous measurement unintentionally still being
active.
► Press the PRESET key.
Resetting the R&S FSH
A "Reset to Factory Settings" resets the R&S FSH to the factory defaults.
During a reset, the R&S ZVH restores the original configuration. It also deletes all
customized datasets (limit lines, standards, channel tables, cable models etc.).
Instead, it will reinstall all the datasets that have been available after delivery.
Risk of data loss
All datasets you have saved will be deleted during a factory reset.
► In the "Instrument Setup" dialog box, select the "Reset to Factory Settings" item.
► Press the ENTER key.
The R&S FSH initiates the reset procedure and shows a warning message box.
Selecting "Yes" performs the reset. During the reboot, it shows a corresponding
message.
Selecting "No" cancels the reset.