R&S FSH Digital Modulation Analyzer
General Result Displays of the Digital Modulation Analyzer
Operating Manual 1173.6275.12 - 30 250
The Isotropic Antenna Result Display
The isotropic antenna result display also provides an overview of the spectrum.
The results of measurements with an
isotropic antenna are based on data
from the three axes of the antenna.
When performing measurements with
an isotropic antenna, the R&S FSH
performs a measurement on each of
the three antenna axes and then
averages the results to draw the trace.
Measurement speed will decrease
because of the multiple
measurements.
You can see the results for each antenna axis (x, y and z) and for the channels that are
part of the signal in a table above the diagram area.
► Press the "Result Display" softkey.
► Select the "Isotropic Antenna" menu item.
For more information on isotropic antennas see "Using Isotropic Antennas" on page
92.
While using the isotropic antenna result display, you can set up the measurement as
usual.
Results in other result displays
When you measure with an isotropic antenna, the other result displays (for example
the numerical result summary) always show the results that were measured in the x-
direction.
To Next Page
Loading...
