Rohde & Schwarz FSH4 - Performing Single Frequency Measurements; Selecting the Measurement Mode

R&S FSH Receiver Mode (R&S FSH-K43)
Selecting the Measurement Mode
Operating Manual 1173.6275.12 - 30 232
8.1 Selecting the Measurement Mode
In receiver mode, the R&S FSH features two measurement modes.
● Fixed Frequency / Channel
● Frequency Scan / Channel Scan
Fixed measurement mode is designed for measurements on single frequencies. Scan
measurement mode performs scans on a defined set of frequencies.
8.1.1 Performing Single Frequency Measurements
The R&S FSH shows the result of the single frequency measurement in a result
display that contains three main elements.
● Measurement (or receive) frequency
● Power level measured at the receive frequency
● Horizontal bargraph that graphically represents the currently measured power
level.
In the default state, the R&S FSH performs the measurement on a single receive
frequency. If it instead shows the result display for a frequency scan, you can access
the single frequency result display manually.
► Press the MEAS key.
► Press the "Fixed Freq" softkey.
The R&S FSH shows the result display for single frequency measurements.
Screen layout of the bargraph result display
1 Measurement mode
2 Operating mode
3 Header table
4 Receive frequency and corresponding power level (numerical)
5 Bargraph
6 Receiver softkey menu