Front and Rear Panel View
R&S
®
FSVA/FSV
18Quick Start Guide 1321.3066.02 ─ 06
Function key Assigned functions
Navigation functions
USER Allows you to define and use softkeys to load user-specific set-
tings files.
HOME Jumps to the highest softkey menu level of the current firmware
option.
Measurement settings
FREQ
(CHANNEL)
Sets the center frequency as well as the start and stop frequen-
cies for the frequency range under consideration. This key is also
used to set the frequency offset and the signal track function.
(CHANNEL for special applications)
SPAN Sets the frequency span to be analyzed.
AMPT
(SCALE)
Sets the reference level, the displayed dynamic range, the RF
attenuation and the unit for the level display.
Sets the level offset and the input impedance.
Activates the preamplifier (option RF Preamplifier, R&S FSV-
B22).
(SCALE for special applications)
AUTO SET Enables automatic settings for level, frequency or sweep type
mode.
BW Sets the resolution bandwidth and the video bandwidth.
SWEEP Sets the sweep time and the number of measurement points.
Selects continuous measurement or single measurement.
TRACE Configures the measured data acquisition and the analysis of the
measurement data.
TRIG Sets the trigger mode, the trigger threshold, the trigger delay, and
the gate configuration in the case of gated sweep.
Marker functions
MKR Sets and positions the absolute and relative measurement mark-
ers (markers and delta markers).
PEAK SEARCH Performs a peak search for active marker. If no marker is active,
normal marker 1 is activated and the peak search is performed
for it.
Front Panel View
To Next Page
Loading...
