Rohde & Schwarz R&S SMA100B - Lifting and Carrying; 4 Preparing for Use; Unpacking and Checking

Preparing for Use
R&S
®
SMA100B
15Getting Started 1419.8620.02 ─ 08
4 Preparing for Use
This chapter describes the basic steps to be taken when setting up the product
for the first time.
4.1 Lifting and Carrying
See also "Lifting and carrying the product" on page 8.
► WARNING! The R&S SMA100B can be heavy, e.g., if fully equipped. Use a
lifting equipment, see also "Lifting and carrying the product" on page 8.
Use the carrying handles at the side for lifting and carrying the
R&S SMA100B.
The handles at the front are only for pushing and pulling the instrument when
mounting in a rack, see Chapter 4.4.2, "Mounting the R&S SMA100B in a
Rack", on page 17.
4.2 Unpacking and Checking
1. Unpack the R&S SMA100B carefully.
2. Retain the original packing material. Use it to protect the control elements and
connectors when transporting or shipping the R&S SMA100B later.
See also chapter "Transporting" in the user manual.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact
Rohde & Schwarz.
Unpacking and Checking