Rohde & Schwarz R&S SMA100B - Rf 50 Ω

Instrument Tour
R&S
®
SMA100B
34Getting Started 1419.8620.02 ─ 08
The R&S SMA100B supports the use of R&S NRP power sensors in various
ways including the use as a power viewer.
The female connector allows the mechanical connection of 6-pole and 8-
pole male connectors.
It mates with the interface cables R&S NRP-ZK8 and R&S NRP-ZK6, used
for connecting R&S NRPxx power sensors, and also with the six-pole push-
pull plugs of the R&S NRP-Zxx series.
However, the signal pair of the common time base clock assigned to the two
pins in the center of the male connectors is not available. These pins are
used by Rohde & Schwarz power meters to synchronize several power sen-
sors.
How to: Chapter "Using Power Sensors" in the user manual
5.1.11 RF 50 Ω
Output of the RF signal.
The connector type depends on the installed frequency option.
Table 5-7: RF connector types of the frequency options
Installed RF frequency
option
Connector type Frequnecy range
R&S SMAB-B103 N female f
max
≤ 6 GHz
R&S SMAB-B106
R&S SMAB-B112 PC 2.92 mm female
Instrument equipped with interchangeable
PC 2.92 mm test port adapter.
f
max
≤ 40 GHz
R&S SMAB-B120
R&S SMAB-B131
R&S SMAB-B140(N)
R&S SMAB-B150(N) PC 1.85 mm female
Instrument equipped with PC 1.85 mm inter-
changeable female/female wear and tear
adapter.
f
max
≤ 67 GHz
R&S SMAB-B167(N)
Front Panel Tour