Rohde & Schwarz R&S SMA100B - Connecting to LAN; Connecting USB Devices

Preparing for Use
R&S
®
SMA100B
20Getting Started 1419.8620.02 ─ 08
The required ratings are listed next to the AC power connector and in the data
sheet.
4.7 Connecting to LAN
You can operate the R&S SMA100B via LAN (local area network) or you can
operate it locally. This section describes how to connect the instrument to a LAN
to operate or control the instrument remotely via a PC in a LAN.
The connector is located on the rear panel.
► Connect the LAN socket via an RJ-45 cable to the LAN.
By default, the R&S SMA100B is configured to use DHCP (dynamic host configu-
ration protocol) and no static IP address is configured.
If switched on and connected to the LAN, the R&S SMA100B displays the
address information on the screen.
Figure 4-1: IP address indication on the screen (example)
See also the chapter "Connecting the Instrument to the Network (LAN)" in the
user manual.
4.8 Connecting USB Devices
USB connectors are located on the front panel and rear panel. You can connect
or disconnect all USB devices from the R&S SMA100B during operation.
Connecting USB Devices