Instrument Tour
R&S
®
SMA100B
38Getting Started 1419.8620.02 ─ 08
See also "Annex: Hardware Interfaces" and chapter "Network and Remote Con-
trol" in the user manual.
USB/USB In
●
Female USB type A connector, to connect devices like a keyboard, a mouse,
a memory stick, or the R&S NRP-Z3/Z4 cable for the R&S NRP power sen-
sors
●
Option: R&S SMAB-B86
Female USB In connector (USB type B), for example for remote control.
How to: Chapter 4.8, "Connecting USB Devices", on page 20
LAN
RJ-45 connector to connect the R&S SMA100B to a LAN for remote control,
remote operation, and data transfer.
How to: Chapter 4.7, "Connecting to LAN", on page 20
V/GHz X-Axis
Output of a voltage ramp:
●
"V / GHz": the voltage is proportional to the frequency.
●
"X-Axis": output of a voltage ramp for the X deflection of an oscilloscope or an
XY recorder.
Z-Axis
Output of a voltage pulse, e.g. for the combined blanking and marker generation
of network analyzers.
Stop
Input and output for stopping the sweep in all modes.
This connector is bidirectional. Used as:
●
"Input": enables you to stop a sweep triggered by an external network ana-
lyzer.
●
"Output": enables the R&S SMA100B to stop the sweep of an external net-
work analyzer.
Marker User1
Output signal for marker or trigger signal.
Signal Valid
Output signal that marks the valid signal times (valid level and frequency) for all
analog modulations.
Rear Panel Tour
To Next Page
Loading...
