Rohde & Schwarz R&S SMA100B - Page 46

Trying Out the Instrument
R&S
®
SMA100B
46Getting Started 1419.8620.02 ─ 08
a) Select "Mode > Auto" to run the sweep continuously.
b) Select "Shape > Sawtooth" to set the waveform shape of the sweep signal.
c) Select "Spacing > Linear", to determine the calculation method for the fre-
quency shift of a step.
d) Set "Dwell Time > 15.0 ms", to determine the time interval of the sweep
steps.
5. Select the "Frequency Range" tab.
Generating an RF Frequency Sweep Signal