Rohde & Schwarz RTM3000 Series - Page 11

Contents
R&S
®
RTM3000
11User Manual 1335.9090.02 ─ 09
14.7.3 Turn ON/OFF time.......................................................................................................381
14.7.4 Safe operating area (S.O.A.).......................................................................................384
15 Logic analyzer (option R&S RTM-B1, MSO).................................... 392
15.1 Short menu for logic channels................................................................................ 392
15.2 Logic analyzer settings............................................................................................ 394
15.3 Triggering on logic channels................................................................................... 396
15.4 Analyzing logic channels......................................................................................... 396
15.5 Parallel buses............................................................................................................ 397
15.5.1 Parallel bus configuration............................................................................................397
15.5.2 Decode results............................................................................................................ 399
16 Signal generation (option R&S RTM-B6)......................................... 401
16.1 Function generator................................................................................................... 401
16.1.1 Using the function generator....................................................................................... 401
16.1.2 Basic settings of the function generator...................................................................... 404
16.1.3 Sweep settings............................................................................................................407
16.1.4 Modulation settings..................................................................................................... 408
16.1.5 Burst settings.............................................................................................................. 410
16.1.6 Arbitrary setup settings................................................................................................411
16.2 Pattern generator...................................................................................................... 413
16.2.1 Pattern selection......................................................................................................... 413
16.2.2 Settings for square wave pattern................................................................................ 414
16.2.3 Settings for counter pattern.........................................................................................415
16.2.4 Settings for arbitrary pattern........................................................................................416
16.2.5 Settings for manual pattern......................................................................................... 419
16.2.6 Settings for serial buses..............................................................................................419
16.2.7 Settings for PWM signals............................................................................................ 420
17 Remote control commands...............................................................423
17.1 Conventions used in command description.......................................................... 423
17.2 Programming examples........................................................................................... 424
17.2.1 Documenting results................................................................................................... 424
17.2.2 Firmware update......................................................................................................... 428
17.2.3 Search.........................................................................................................................429