Rohde & Schwarz Scope Rider RTH - Page 145

Multimeter Measurements
R&S
®
Scope Rider RTH
145User Manual 1326.1578.02 ─ 12
1. Connect the leads first to the DMM inputs at the top of the instrument, and then to
the DUT.
2. To start meter measurements, press the [DMM] key.
7.1.2 Accessing the Meter Mode
► There are several ways to start the multimeter mode:
● Press the [DMM] key.
● Press the [MODE] key, and select "Meter".
● To start relative measurements, press the [DMM REL] key.
The multimeter interface is displayed, and the measurement is started immediately.
7.1.3 Display and Control
The multimeter display shows detailed results and setup icons.
Digital Multimeter (R&S RTH1002)