Rohde & Schwarz Scope Rider RTH - External Trigger (R&SRTH1002); Pattern Trigger (R&SRTH-K19)

Remote Control Commands
R&S
®
Scope Rider RTH
318User Manual 1326.1578.02 ─ 12
Parameters:
<SyncPulseDuration> Range: 100E-9 to 100E-6
Increment: 100E-9
*RST: 4.7E-6
Default unit: s
TRIGger:TV:CUSTom:SCANmode <ScanMode>
Sets the scanning system.
For details, see "Scan" on page 61.
Parameters:
<ScanMode> INTerlaced | PROGressive | SEGMented
*RST: INTerlaced
15.3.5.6 External Trigger (R&S RTH1002)
TRIGger:EXTernal:LEVel................................................................................................ 318
TRIGger:EXTernal:SLOPe.............................................................................................. 318
TRIGger:EXTernal:LEVel <Level>
Sets the trigger voltage level.
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:EXTernal:SLOPe <Slope>
Sets the edge direction for the trigger. You can trigger on the rising edge, the falling
edge, or riding and falling edges of the external signal.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
15.3.5.7 Pattern Trigger (R&S RTH-K19)
See also Chapter 3.6.7, "Pattern Trigger (R&S RTH-K19)", on page 62.
TRIGger:PATTern:STATe[:CHANnel<m>].......................................................................... 319
TRIGger:PATTern:STATe:COMBination.............................................................................319
TRIGger:PATTern:WIDTh:RANGe....................................................................................319
TRIGger:PATTern:TIMeout[:TIME]....................................................................................320
TRIGger:PATTern:WIDTh[:WIDTh]................................................................................... 320
Waveform Setup