Rohde & Schwarz Scope Rider RTH - Page 172

Protocol Analysis
R&S
®
Scope Rider RTH
172User Manual 1326.1578.02 ─ 12
Figure 9-1: Bus menu. Left: for protocols without address (SPI, UART). Right: for protocols with
address or identifier (I²C, CAN, LIN, SENT)
For all serial protocols, the following settings are required:
State
Enables the decoding and the display of the serial bus data.
Remote command:
BUS[:STATe] on page 426
Bus Protocol
Defines protocol type of the bus for configuration and trigger settings.
Remote command:
BUS:TYPE on page 426
Display Format
Sets the decoding format of data values: binary, hexadecimal, decimal, octal, or ASCII.
The format is used in comb display and in the protocol table. Address values are
always hex values.
Remote command:
BUS:FORMat on page 426
Basics of Protocol Analysis