Instrument Control
R&S
®
SMB100A
68Quick Start Guide 1407.0812.62 ─ 20
●
Winbar with labeled softkeys for menu display.
The block diagram in the figure below shows a fully equipped instrument.
Figure 8-1: Block diagram of a fully equipped R&S
SMB
8.1.3.1 Settings Displayed in the Header Section
Frequency/level settings and a few status messages (see Chapter 8.1.3.2, "Status
Information and Messages", on page 68) are displayed in the header field of the
screen. The display may vary depending on the instrument's operating mode:
●
In the sweep mode, the current frequency or level of the output signal is displayed.
The status message "SweepMode" is displayed in the info line.
●
In the list mode, neither the current frequency nor level is displayed, the indication
is dimmed.
●
If user correction is active, the status message "UCorr" is displayed in the info line.
The values displayed in the "Freq" and "Level" fields include a set offset or multiplier
factor.
See also "RF Frequency and Phase" and "RF Level" in the Operating Manual.
The frequency and level indication can be enlarged so that it covers the complete dis-
play of the R&S SMB by using the [DIAGR] key. This key toggles between block dia-
gram, magnified frequency and level indication and the display of the active dialog.
This requires the "Summary Screen Toggle" to be enabled.
See chapter "Display/Keyboard Settings" in the operating manual.
8.1.3.2 Status Information and Messages
The instrument indicates status information and messages in the header section of the
screen. The messages differ with respect to their importance (errors, warnings, info)
and the time of their appearance (brief and permanent messages), and require differ-
ent treatment
For additional information refer to the info window (see Chapter 8.1.3.3, "Info Window",
on page 69).
Manual Operation
To Next Page
Loading...
