Instrument Tour
R&S
®
SMB100B
30Getting Started 1422.1045.02 ─ 01
Further USB interface type A (host USB) and a USB interface type B (USB
In) are available on the rear panel.
See also Chapter 3.2, "Connecting USB Devices", on page 20.
4.1.9 RF 50 Ω
Output of the RF signal.
Maximum input levels
Do not overload the RF output.
The instrument is equipped with a reverse power protection that prevents
the RF output against back feed, see section "Reverse Power Protection" in
the user manual. The maximum permissible reverse power is specified in
the data sheet.
The connector type depends on the installed frequency option.
Risk of RF connector and cable damage
If you tighten the connectors too strongly, you can damage the cables and
connectors. If you do not tighten the connectors enough, the measurement
results can be inaccurate.
Always use an appropriate torque wrench suitable for this type of connector
and apply the torque specified in the application note 1MA99.
The application notes are available on the Internet and provide additional
information on care and handling of RF connectors.
Rohde & Schwarz offers appropriate torque wrenches for various connec-
tors. For ordering information, see the R&S SMB100B data sheet or product
brochure.
Front Panel Tour
To Next Page
Loading...
