Trying Out the Instrument
R&S
®
SMB100B
40Getting Started 1422.1045.02 ─ 01
6. In the "General" tab, activate the frequency sweep with "State > On".
7. Close the sweep dialog.
(Alternatively, tap the "Home" button to minimize the dialog. The
R&S SMB100B indicates the "Sweep" dialog as active dialog in the task bar.)
8. To activate the RF signal output, select "Level" > "RF On".
Figure 5-2: Generating a frequency sweep signal
The frequency field in the status bar indicates the continuously changing fre-
quency, i.e. the running sweep.
5.3 Saving and Recalling Settings
To restore the results of our measurements later, we save the instrument settings
in a file.
To save the instrument settings in a file
We assume, a test configuration as described in Chapter 5.2, "Generating an RF
Frequency Sweep Signal", on page 38.
1. Press the [Setup] key on the front panel.
Saving and Recalling Settings
To Next Page
Loading...
