Trying Out the Instrument
R&S
®
SMB100B
37Getting Started 1422.1045.02 ─ 01
Figure 5-1: Generating an unmodulated signal
Alternative ways to access the instrument functions
To fulfill the same task, you can also use the front panel keys or the setting
parameters provided in the frequency and level dialogs.
Try out the settings dialogs
1. In the "Frequency" tile, select "Frequency...".
a) In the "RF Frequency" tab, tap the "Frequency" field.
b) Set the frequency via the on-screen keypad.
2. Access the "RF Level" dialog via the "Level" tile.
a) In the "RF Level" tab, select "Amplitude".
b) Set the amplitude (level) via the on-screen keypad.
3. Select "RF State > On" to activate the RF signal generation.
Try out the front panel keys
► Use the [Freq], [Level], and [RF on/off] key on the front panel.
Generating an Unmodulated Carrier
To Next Page
Loading...
